Prosport 52mm Gauge Hood
The Prosport gauge hood can be used on any 52mm gauge or used to angle your gauges when installed backwards. Keep in mind all Prosport gauges already comes with a hood.
Prosport 5 Piece Metric Gauge Sender Adapter Kit
Prosport offers an easy way to install senders for any foreign car. The kit comes with 5 different 1/8" NPT threaded center adapters. This Kit includes: M16x1.5, M14x1.5, M12x1.0, M10x1.0, 1/8"BSP.
Prosport Oil Filter Adapter Plate For Subaru
This is a great product to make installing your Oil Pressure Sender and Oil Temp. senders easier. This screws on under your oil filter and it has two 1/8"NPT fittings. So, no more drilling and taping holes. Just screw this adapter on and screw in our Oil Pressure or Oil Temperature senders. M20-Fits most Subaru's.
Prosport Oil Pressure Sender
Prosport's Dual Post Oil Pressure sender (VDO type) is 3-160 oHms, 0-10 BAR, 0-150 PSI and features 1/8" NPT thread.
Prosport Oil or Water Temperature Sensor For Stepper Motor Gauges
The Prosport temperature sender can be used for water, engine oil and transmission oil. The sender features 1/8" NPT thread, 32-925 oHms and 68°F-302°F Range. The sensor is made for the Prosport Performance and Premium gauges that are 1 1/2" long front to back. Excluding the EVO series, Clear Lens Performance and 60mm Performance series.
Prosport Remote Oil Pressure Sender Installation Kit
The Prosport Remote Oil Sender Install Kit is required when an oil pressure sender is too large to fit into and an OEM oil galley plug (Clearance Issues). The Prosport kit includes everything you need to mount any oil pressure sender with an 1/8" NPT fitting. The kit includes an oil galley plug, 24" stainless steel braided hose, stainless steel cushioned mounting bracket, hardware and instructions.
Prosport Premium Oil / Fuel Pressure Sender
The Prosport Oil / Fuel pressure sender is designed to work the Prosport Premium Series Oil Pressure and Fuel Pressure Gauges. The sender features: 0-5 Volt, 0-150 PSI and 1/8" NPT thread. *This sender cannot be used with Performance Series Gauges.
Prosport 28mm Radiator Hose Adapter For Water Temperature Sender
Made from 6061 Aluminum this in-line radiator hose adapter will make installing your temperature sender a breeze. This will place the temperature sensor directly in the stream of the water towards the radiator without absorbing transient heat from the engine block for accurate readings of the water temperature. Each adapter features an 1/8" NPT fitting. Simply insert into your upper radiator hose and tighten the included hose clamps. Measure the inside diameter to choose the correct size for your vehicle.